Create your own DIY mounting location for the Husky Buildout system of toolboxes
Includes 4 Corner Brackets and 2 sliding cleats
Compatible with full-size boxes and half size
Install Instructions:
Place a box where you would like to mount it
Place corner brackets on the inside of the corner bumpers
Lift the box up
Screw the corner brackets down
Place the box back down- ensure the corners are attached properly
Place the sliding cleats into the receivers on each side of the box. Mark the outer edges of the slot or drill, and install a screw on the outer edge of the slot.
If the screw is installed too close to the inside of the box, then it will not slide properly
Tighten the screw for the desired resistance when sliding the cleat in and out
Create your own DIY mounting location for the Husky Buildout system of toolboxes
Includes 4 Corner Brackets and 2 sliding cleats
Compatible with full-size boxes and half size
Install Instructions:
Place a box where you would like to mount it
Place corner brackets on the inside of the corner bumpers
Lift the box up
Screw the corner brackets down
Place the box back down- ensure the corners are attached properly
Place the sliding cleats into the receivers on each side of the box. Mark the outer edges of the slot or drill, and install a screw on the outer edge of the slot.
If the screw is installed too close to the inside of the box, then it will not slide properly
Tighten the screw for the desired resistance when sliding the cleat in and out
